Garage Door Springs Replacement

Getting Started
How To replace your garage door springs by following these Easy Steps
This can be a daunting task without the proper directions. Here they are for your use.

Step 1. Before getting started on the replacement, it is essential that we begin these instructions with our sternest warning for safety. This will mean that you will need to be completely at ease with your capability to read and adhere to the instructions that came with the new spring. If you choose not to do that or forget it, you’ll expect some kind of accident to happen and cause serious bodily impairment.

Step 2. At all times wear eye protection and gloves. This part is very important because if the springs break as you are unwinding them, parts and pieces may fly directly toward you at high speed.

Step 3. You must have the following tools; crescent wrench, 1 or 2 vise-grip wrenches, 2 pipes approximately 18\” long by either 5/8 or 1/2 diameter and a top quality ladder. Make sure you have a well-lighted garage and clear access to the motor and existing springs. Be well prepared before you start any unwinding.

Step 4. Measure your old spring, and then check the new spring to make sure it is the same length and same amount of coils. . This is going to involve counting the coils on your existing spring, and you will also need to make sure that the spring is on the correct side of the door as the are handed.

Step 5. Right now I like to take a couple of photograph of my existing springs so that I have a reference to go back to if necessary. An important factor you will want to remember here will be if you don’t feel comfortable doing this by yourself, this is the point at which you should find a helper.
Why this can be highly recommended is there is nothing worse than being stuck up on a ladder with the tension on the spring released and your second pipe laying on the ground by the foot of your ladder..

Step 6. One last time check to make certain there is nothing in the way of your area in which you need to work and you have all your tools handy and in good working order.
.

Step 7. It is now time for the real work to begin.